Similar Topics: Cable Assembly
Cable Assemblies
enable IO signal paths.
See Also: Cables, Interconnects, Flying Leads, Instrument Cables, Patchcords
-
product
BNC Connection and Cables
All Spectrum BNC connections are BNC female. A cable with a BNC male connector is needed to attach to the Spectrum product.
-
product
Test, Map, Profile and Qualify "Dark" Coax Cable Networks
Coax Clarifier
Dark unpowered coax systems give no clue as to their design, condition or configuration. The new Coax Clarifier by T3 Innovation makes it simple and easy to discern the layout of a coax network, locate faults on individual cable runs, identify remotes through splitters, and determine cable run length. In addition, separate wiremapping sets allow a technician to map out the entire coax system and measure the quality and characterization of the overall network for carrying services, such as high grade video, surveillance data and HD programming.
-
product
Cables Testing Equipment
Quality control in the cable and wire production industry requires high voltage testing of the insulating coating just after it has been applied.
-
product
Cable Assembly, Receiver, QuadraPaddle, 36", 2 VHDCI, for PXIe-8431/16
540205040240
Cable Assembly, Receiver, QuadraPaddle, 36", 2 VHDCI, for PXIe-8431/16
-
product
Cable Assembly, Receiver, TriPaddle, 36"
540282010203
Cable Assembly, Receiver, TriPaddle, 36"
-
product
USB 3 cable, 3 meter, A to Micro B Jackscrews
156391-03
4-Pin Male USB 3.0 Micro-B Jackscrew to 9-Pin Male USB 3.0 Type A Jackscrew or 9-Pin Male USB 3.0 Type A USB 3.0 Cable - The USB 3.0 Cable is the standard cable for USB3 Vision cameras and USB 3.0 interface boards. The USB3 Vision standard provides 400 MB/s bandwidth. The USB 3.0 Cable is offered in different lengths.
-
product
30" Ribbon Cable
CONM50-D37-30
A 30" ribbon cable transitions from individual IP modules on various carrier boards to a 37 pin D-sub female connector mounted on a PC expansion card end-panel. This allows external connection to pins 1-37 on an individual IP Module.
-
product
Low Profile Cable, 37-pin DSUB to signal wires (4m)
782316-04
37-Pin D-SUB Female to 37-Pin Bare Wire Female, 4 m, Pigtail I/O, Shielded Multifunction Cable - The SH37F-Pigtail LP Cable connects with compatible CompactRIO modules to accessories or cables with bare wire connectors.
-
product
Cable Assy 26-Pin D-Type F/F 1m
40-970-026-1m-FF
26-Pin Female to Female D-Type Cable Assy, 1m Long
-
product
SMB Female to BNC Male Cable, 50 Ohm, 1 m (Quantity 8)
778414-01
The SMB-BNC Coaxial Cable, sometimes referred to as SMB-100 or SMB-110, connects measurement and signal devices. NI offers this 50 Ω cable in different lengths and quantities.
-
product
Cable Tester
The Cable Test System is a perfect example of a special solution built on existing DapTechnology building blocks. The system, which was developed with the cooperation of a key A&D cable harness supplier, replaces a cable test system with proven FireSpy Technology.
-
product
Cable Testers
LINKMASTER
The LinkMaster Tester consists of two units. The main unit is connected to one end of the cable to be tested and the remote unit is connected to the jack at the far end of the cable (wall outlet, patch panel port, etc.)
-
product
Cable, 25 Pin 1.27mm Pitch Micro-D, Female to Unterminated, Cut Ends, 0.5m
A025CFR-C-5A050
This 0.5m long female 25-Pin Micro-D to unterminated (with cut ends) cable assembly is constructed from 18/0.1 (26 AWG) copper wiring with PVC insulation and screening to minimise crosstalk. Screwlocks are provided to secure the connector to its associated product.
-
product
Cable Assy 26-Pin D-Type F/F 2m
40-970-026-2m-FF
The 26-Pin D-Type cable assembly is constructed from 7/0.15 (26AWG) Silver Plated Copper Wire with PFA insulation. Screwlocks are provided to secure the connectors to their associated products. The 26-Pin Female connector option of this cable assembly is suited for direct connection to Pickering Interfaces products.
-
product
Detection of PtG and PtP Faults on Multi and Single Core Cables
CableTroll 2350
CableTroll 2350 is an indicator for detection of PtG and PtP faults on multi and single core cables. The unit uses standard type current transformers. (40:1, 60:1 or 3x500:1)
-
product
20-Pin GMCT Cable, Female to Unterminated, Tinned Ends, 10A, 1m
A020GFR-T-0C100
The 20-Pin GMCT cable assembly is constructed from 19/0.254 (18AWG) Tinned Copper Wire with PFA insulation. Screwlocks are provided to secure the connector to associated product. The unterminated connections are coded to match the connector pin designation. Users may need to make their own cable strain relief arrangements when using this product and should ensure appropriate electrical safety precautions are observed.
-
product
3-Pin Power D-Type Connector & Cable Accessories
Our 3-Pin D-Type connector is used on PXI switching products to provide a low density user connector solution.
-
product
Accessories & Cables
Active Silicon offer a range of accessories for our hardware products, including CoaXPress and Camera Link cables and FireBird IO adapters for use with our frame grabbers. The products listed on our website are in stock and readily available. Other cable lengths or adapter types, are available on request, especially for higher order volumes.
-
product
MCX Male to MCX Male Cable, 50 Ohm, 30 cm
188374-0R3
The MCX-MCX Coaxial Cable is used for modular instruments such as PXI switches. This cable is available in 1 m, 30 cm and 15 cm lengths.
-
product
Ultrasonic Probes And Cables
The cable connects the main body of ultrasound diagnostic equipment and the probe used for echographic investigation.
-
product
MOTORIZED TRANSFORMER/RECTIFIER ASSEMBLY, 0-250 VDC, 200 A OUTPUT
18534PS1
Input power is 380 VAC, 3 PH, 50 Hz, P/N 18534PS1Output is 0 to 250 VDC, 200 Amp max.Variable Transformer is used to vary the output. SCR controller is not used, as it generates harmonics.Input control is 0 to 3.6 VDCIndoor enclosure, 50"H x 46"W x 36"DOutput voltage and current feedback as 4/20 mA for PLC interface.All input/output connections are inside the enclosure
-
product
20-Pin GMCT Cable, Female to Unterminated, Ferrules, 16A, 2m
40-972C-020-2m-FU
The 16A 20-Pin GMCT cable assembly is constructed from 19/0.41 (14AWG) Copper Wire with PFA 500V insulation. Screwlocks are provided to secure the connector to associated product. The unterminated connections are coded to match the connector pin designation and include crimped on ferrules to ensure the wire strands cannot break when they are terminated.
-
product
CableEye Cable Testing
A industry-grade, Windows PC driven cable tester with incredible performance yet amazingly simple to operate. CableEye cable testing has found itself in areas as diverse as working in oil/gas mining through avionics and F1 car testing to audio cables at concerts.
-
product
Network Cable Tester
AudioJog Pro 8
Audio/Lighting/Network cable tester with SINGLE & DOUBLE ended testing.
-
product
Cable Locators & Testers
PeakTech Prüf- und Messtechnik GmbH
This new cable detector consisting of a transmitter and a receiver is suitable for the search of voltage-free and voltage - carrying lines, as well as line interruptions and line tracking of surface and flush-mounted lines, pipe systems and even lines in the ground.
-
product
Low Loss Test Cables
SF Series
SuperFlexLow Loss Test Cables are very flexible, low loss and DC-26.5 GHz
-
product
Power Sensor and SNS Noise Source Cable (6.1m/20 feet)
11730C
The Keysight 11730 series power sensor cables are used with the 8480 and E-series power sensors (except the E9320 family of peak and average sensors). These cables are designed to reduce RFI effects on low power readings with an improved shielding design in the cable itself. Cables may be ordered individually or in pairs in any combination desired for single and dual-channel measurements.
-
product
Ruggedized Ethernet Cables
Teledyne Marine Cable Solutions
Ruggedized Ethernet cables from Teledyne Storm Cable are used in a variety of applications, from the land based Oil & Gas industry to deep water subsea applications. The cables are designed to maintain the integrity of high speed Ethernet data transmission while surviving in harsh environments.
-
product
Cable 96-Pin Micro-D Female to Unterminated, Tinned Ends, 1m
A096SFR-T-5A100
The 96-Pin SCSI Style Micro-D to Unterminated Cable Assy is constructed from 28 AWG Twisted Pair Tinned Copper wire with Polyolefin insulation. Crosstalk is minimised. Wires are colour coded for easy connection. Metal Spring Latches are provided on the 96-Pin connector.
-
product
Cable
RCONQPMC-2
RCONQPMC-2 - Transitions from a SCSI-68 pin connector to four CJ70 Twinax, 3 lug, 1553 cable jack ends and one D-Sub 50 pin connector for additional I/O.